LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Electronic Engine Controls - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560) >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel >> Removal And Installation >> Oil Pressure And Temperature Sensor (G1892882) >> Installation

Oil Pressure And Temperature Sensor (G1892882): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the oil pressure and temperature sensor.

    Torque  : 15 Nm 

  2. Install the wiring harness and connect the electrical connector for the oil pressure and temperature sensor.
  3. Install the accessory drive belt.

    Refer to: ACCESSORY DRIVE BELT

  4. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals