LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Electronic Engine Controls - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560) >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel >> Removal And Installation >> Intake Air Temperature Sensor (G2110326) >> Installation

Intake Air Temperature Sensor (G2110326): Installation

WARNING: This page is about a different variant/trim than selected.
  1. NOTE: Install a new O-ring seal.

    Install the IAT sensor and tighten the retaining screws to the correct torque.

    Renew Part: Mass air flow sensor O-ring seal Quantity: 1  .

    Torque  : 1.9 Nm 

  2. Install the air cleaner assembly.

    Refer to: AIR CLEANER

  3. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals