LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Electronic Engine Controls - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560) >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel >> Removal And Installation >> Cylinder Head Temperature Sensor (G1947561) >> Installation

Cylinder Head Temperature Sensor (G1947561): Installation

WARNING: This page is about a different variant/trim than selected.
  1. CAUTION: A new cylinder head temperature sensor must always be installed.

    Install a new cylinder head temperature sensor and tighten to correct torque.

    Renew Part: Cylinder head temperature sensor Quantity: 1  .

    Torque  : 10 Nm 

  2. Connect the cylinder head temperature sensor electrical connector. Then secure the wiring loom in the correct position with the retaining clip.
  3. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

  4. Install the intake air resonator.

    Refer to: INTAKE AIR RESONATOR

scientia non olet · About LEMON Manuals