LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Electronic Engine Controls - INGENIUM I4 2.0L Diesel -- Range Rover Velar/L560) >> Electronic Engine Controls - INGENIUM I4 2.0L Diesel >> Removal And Installation >> Crankshaft Position Sensor (G2110303) >> Installation

Crankshaft Position Sensor (G2110303): Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the CKP sensor and tighten the retaining bolt to the correct torque.

    Torque  : 8 Nm 

  2. Install the engine undershield.

    Refer to: ENGINE UNDERSHIELD

  3. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals