LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Body Panel System - Front End Body Panels -- Range Rover Velar/L560) >> Front End Body Panels >> Removal And Installation >> Secondary Bulkhead Right Panel - INGENIUM I4 2.0L Diesel (G2020321) >> Installation

Secondary Bulkhead Right Panel - INGENIUM I4 2.0L Diesel (G2020321): Installation

WARNING: This page is about a different car, the 2019 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.
    • Install the secondary bulkhead right panel.
    • Install and tighten the 5 bolts.

      Torque  : 5.4 Nm 

    • Reposition and secure the wire harness.
    • Connect the 2 electrical connectors.

      Torque  : 3.6 Nm 

    • Install the engine compartment brace.
    • Install and tighten 4 bolts.

      Torque  : 55 Nm 

  4. Install the cowl panel.

    Refer to: COWL PANEL 

  5. Install the engine cover.

    Refer to: ENGINE COVER - INGENIUM I4 2.0L DIESEL

  6. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals