LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Body Panel System - Front End Body Panels -- Range Rover Velar/L560) >> Front End Body Panels >> Removal And Installation >> Secondary Bulkhead Lower Panel - V8 S/C 5.0L Petrol (G2340002) >> Installation

Secondary Bulkhead Lower Panel - V8 S/C 5.0L Petrol (G2340002): Installation

WARNING: This page is about a different car, the 2019 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.
    • Install the secondary bulkhead lower panel.
    • Install the 2 retaining bolts.

      Torque  : 5.4 Nm 

  2. Connect the steering column intermediate shaft to the steering column.

    Refer to: LOWER STEERING COLUMN TRIM

  3. Install the secondary bulkhead left outer panel.

    Refer to: SECONDARY BULKHEAD LEFT OUTER PANEL - V8 S/C 5.0L PETROL 

  4. Install the secondary bulkhead right outer panel.

    Refer to: SECONDARY BULKHEAD RIGHT OUTER PANEL - V8 S/C 5.0L PETROL 

  5. Install the engine assembly.

    Refer to the appropriate Engine System article

  6. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals