LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Body Panel System - Front End Body Panels -- Range Rover Velar/L560) >> Front End Body Panels >> Removal And Installation >> Secondary Bulkhead Lower Panel - V6 S/C 3.0L Petrol (G2049168) >> Installation

Secondary Bulkhead Lower Panel - V6 S/C 3.0L Petrol (G2049168): Installation

WARNING: This page is about a different car, the 2019 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.
    • Install the secondary bulkhead lower panel.
    • Install and tighten the 2 bolts.

      Torque  : 5.4 Nm 

  2. Install the steering column lower shaft.

    Refer to: STEERING COLUMN LOWER SHAFT

  3. Install the secondary bulkhead left panel.

    Refer to: SECONDARY BULKHEAD LEFT PANEL - V6 S/C 3.0L PETROL 

  4. Install the secondary bulkhead right panel.

    Refer to: SECONDARY BULKHEAD RIGHT PANEL - V6 S/C 3.0L PETROL 

  5. Install the engine assembly.

    Refer to: ENGINE

  6. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals