Secondary Bulkhead Left Panel - INGENIUM I4 2.0L Petrol (G2020320): Installation

WARNING: This page is about a different car, the 2019 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.

- Install the secondary bulkhead left panel.
- Install and tighten the 3 bolts.
  Torque : 5.4 Nm
- Install the auxiliary coolant pump.
- Install and tighten the 2 bolts.
  Torque : 10 Nm
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the fir tree clip.
- Connect the coolant pipe.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the coolant pipe.
- Connect the coolant pipe.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

Connect the coolant pipe.
Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
- Install the fir tree clip.
- Install the coolant pipe into the 3 clips.
Connect the brake booster vacuum hose quick release connector.
- Install the engine compartment brace.
- Install and tighten the 4 bolts.
  Torque : 55 Nm
Install the secondary bulkhead right panel.
Refer to: SECONDARY BULKHEAD RIGHT PANEL - INGENIUM I4 2.0L PETROL
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT