Secondary Bulkhead Left Outer Panel - V8 S/C 5.0L Petrol (G2263567): Installation

WARNING: This page is about a different car, the 2019 Land Rover Range Rover Velar. However, it is still accessible from the selected car via links, so may be relevant.

- Install the secondary bulkhead left outer panel.
- Install and tighten the 2 bolts.
  Torque : 6 Nm
- Position the Air Conditioning (A/C) pipes.
- Install and tighten the bolt.
  Torque : 8 Nm
- Install the exhaust back-pressure sensor and bracket.
- Install and tighten the bolt.
  Torque : 6 Nm
- Install and tighten the 2 nuts.
  Torque : 6 Nm
- Install the ignition coil.
- Install and tighten the bolt.
  Torque : 4 Nm
- Connect the electrical connector.
Remove the oil filler cap.
Install the Noise, Vibration and Harshness (NVH) pad.
Install the oil filler cap.
Install the secondary bulkhead left inner panel.
Refer to: SECONDARY BULKHEAD LEFT INNER PANEL - V8 S/C 5.0L PETROL
Connect the startup battery ground cable.
Refer to: STARTUP BATTERY DISCONNECT AND CONNECT