LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> Engine Mechanical >> Cooling System (Mechanical) >> Engine Cooling - INGENIUM I4 2.0L Petrol -- Range Rover Velar/L560 >> Engine Cooling - INGENIUM I4 2.0L Petrol >> Removal And Installation >> Block Heater (G2033416) >> Installation

Block Heater (G2033416): Installation

  1. CAUTION: Replace the gasket if it is worn.
    • Install the gasket.
    • Install and tighten the block heater.

      Torque  : 55 Nm 

  2. Connect the electrical connector.
  3. Install the generator.

    Refer to: GENERATOR

  4. Vacuum fill the cooling system.

    Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING 

  5. Connect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

scientia non olet · About LEMON Manuals