LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2018 >> Range Rover Velar Base >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Power Brake Actuation -- Range Rover Velar/L560 >> Power Brake Actuation (G2318565) >> Removal And Installation >> Brake Vacuum Pump - INGENIUM I4 2.0L Diesel (G1961669) >> Removal

Brake Vacuum Pump - INGENIUM I4 2.0L Diesel (G1961669): Removal

NOTE:
  • This procedure contains some variation in the illustrations depending on the vehicle specification, but the essential information is always correct.
  • This procedure contains illustrations showing certain components removed to provide extra clarity.
  1. Raise and support the vehicle on a suitable 2 post lift.

    Refer to: LIFTING

  2. Disconnect the startup battery ground cable.

    Refer to: STARTUP BATTERY DISCONNECT AND CONNECT

  3. Remove the oil pump chain.

    Refer to: OIL PUMP CHAIN

  4. Disconnect the electrical connector for the oil pump.
    G11693959Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  5. Release the oil pump wiring harness.
    G11693960Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  6. Remove the brake vacuum pump assembly.
    G11693961Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC
  7. NOTE: Do not disassemble further if the component is removed for access only.
    G11693962Courtesy of JAGUAR LAND ROVER NORTH AMERICA, LLC

    Remove the oil pick-up pipe.

scientia non olet · About LEMON Manuals