LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2016 >> Range Rover Supercharged >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Exhaust System - TDV6 3.0L Diesel -- Range Rover/L405) >> Exhaust System - TDV6 3.0L Diesel >> Exhaust System DTC: Selective Catalytic Reduction (SCR) >> Diagnosis And Testing >> Symptom Chart

Symptom Chart

WARNING: This page is about a different variant/trim than selected.
SYMPTOM POSSIBLE CAUSES ACTION
  • Engine malfunction lamp illuminated
  • Or 
  • Reagent indicator (17MY on)
  • Selective catalyst reduction system failure
  • Diesel exhaust fluid level too low
  • Power or ground failure
  • Diesel exhaust fluid pressure too low
  • Diesel exhaust fluid pressure too high
  • Diesel exhaust fluid injection pump
  • Diesel exhaust fluid injector
  • Diesel exhaust fluid relay
  • Diesel exhaust fluid heater control unit
  • Pre selective catalytic reduction NOx sensor
  • Pre selective catalyst reduction Nox sensor module
  • Post selective catalyst reduction NOx sensor
  • Post selective catalyst reduction Nox sensor module
  • Post selective catalyst reduction soot sensor
  • Post selective catalyst reduction soot sensor module
  • Diesel sub net CAN communication bus
  • Using the Jaguar Land Rover Approved Diagnostic Equipment check engine control module for related DTCs and refer to relevant DTC index
  • Check and correct the diesel exhaust fluid level
  • Refer to the appropriate system wiring diagram and check connections are secure and wiring integrity
  • Refer to the service information and the battery care manual, inspect the vehicle battery and ensure it is fully charged and serviceable before performing further tests
  • Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
  • Refer to the appropriate system wiring diagram and check sensor, relays/fuses and control module power feeds and grounds
  • Check system for correct installation of components
  • Check system mechanical and fluid integrity
  • Check system for mechanical integrity
  • Check system for leakage
  • Check system for blockage
  • Engine will not crank
  • Vehicle battery failure
  • Diesel exhaust fluid level too low
  • Harness failure - Wiring integrity
  • Refer to the service information and the battery care manual, inspect the vehicle battery and ensure it is fully charged and serviceable before performing further tests
  • Inspect connectors for signs of water ingress, and pins for damage and/or corrosion
  • Check and correct the diesel exhaust fluid level
  • Using the Jaguar Land Rover Approved Diagnostic Equipment carry out any required routines
  • Message warning
  • Selective catalyst reduction system failure
  • A monitor of the historical diesel exhaust fluid consumption rate, allied with a direct reading of the diesel exhaust fluid level in the tank, predicts that the distance to emptying the tank is less than 2400km
  • Using the Jaguar Land Rover Approved Diagnostic Equipment check engine control module for related DTCs and refer to relevant DTC index
  • Check and correct the diesel exhaust fluid level