Parameter Identifier (PID)

WARNING: This page is about a different variant/trim than selected.

PID	DESCRIPTION	ACTION
0x043C	Reductant Tank Temperature - Raw	Diagnosis may require using the Jaguar Land Rover Approved Diagnostic Equipment to check datalogger signals Signal is displayed in °C Circuit reference I_T_RAULS Signal Input to the engine control module PWM signal for DEF tank temperature
0x0441	Reductant Injector Duty Cycle	Diagnosis may require using the Jaguar Land Rover Approved Diagnostic Equipment to check datalogger signals Signal is displayed in % Circuit reference O_T_RAMV_L Output from the engine control module PWM signal to drive the DEF injector
0x05C1	Reductant Tank Fluid Level	Diagnosis may require using the Jaguar Land Rover Approved Diagnostic Equipment to check datalogger signals Signal is displayed in mm Circuit reference I_T_RAULS Signal Input to the engine control module PWM signal for DEF tank level
0x05C2	Reductant Tank Sensor Duty Cycles	Diagnosis may require using the Jaguar Land Rover Approved Diagnostic Equipment to check datalogger signals Signal is displayed in % Signal value is read from internal memory location internal to engine control module over CAN communication bus
0x05CF	Reductant Purge Pump Duty Cycle - Commanded	Diagnosis may require using the Jaguar Land Rover Approved Diagnostic Equipment to check datalogger signals Signal is displayed in % Circuit reference O_T_RAPM Output from the engine control module PWM signal to drive the DEF pump
0x05D0	Reductant Pump Duty Cycle - Commanded	Diagnosis may require using the Jaguar Land Rover Approved Diagnostic Equipment to check datalogger signals Signal is displayed in % Circuit reference 0_T_RAPM Output from the engine control module PWM signal to drive the DEF pump
0x05D1	Selective Catalyst Reductant Relay State - Commanded	Diagnosis may require using the Jaguar Land Rover Approved Diagnostic Equipment to check datalogger signals Signal is displayed as off/on Circuit reference 0_T_SCRMRLY Output from the engine control module PWM signal to drive the DEF relay
0x05FB	Learnt Heater Current Threshold For Heater Run Dry Detection - Frozen Cavity Detection In Urea Tank	Diagnosis may require using the Jaguar Land Rover Approved Diagnostic Equipment to check datalogger signals Signal is displayed in mA Signal value is read from internal memory location internal to engine control module over CAN communication bus
0x05FC	Total Mass Of Fluid Injected By Urea Dosing System	Diagnosis may require using the Jaguar Land Rover Approved Diagnostic Equipment to check datalogger signals Signal is displayed in Kg Signal value is read from internal memory location internal to engine control module over CAN communication bus
0x05FD	Total Time Of Urea Dosing Valve Exceeding Upper Temperature Threshold	Diagnosis may require using the Jaguar Land Rover Approved Diagnostic Equipment to check datalogger signals Signal is displayed in s Signal value is read from internal memory location internal to engine control module over CAN communication bus