Removal And Installation: Removal

WARNING: This page is about a different variant/trim than selected.

CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.

NOTE: Some variation in the illustrations may occur, but the essential information is always correct.

Refer to: ENGINE OIL DRAINING AND FILLING
Refer to: EXHAUST SYSTEM - VEHICLES WITH: DIESEL PARTICULATE FILTER (DPF)
Refer to: EXHAUST SYSTEM - VEHICLES WITH: DIESEL PARTICULATE FILTER (DPF)
Refer to: LEFT EXHAUST GAS RECIRCULATION VALVE - TDV6 3.0L DIESEL - GEN 2
Refer to:TRANSMISSION FLUID COOLER TUBES - TDV6 3.0L DIESEL
Torque Specification: 10 Nm
CAUTION: Before disconnecting any components, make sure the area is clean and free from foreign material. When disconnected all openings must be sealed.

NOTE: Install a new gasket.

Renew Part: Turbocharger oil return pipe to cylinder block gasket Quantity: 1 .

Torque Specification: 9 Nm
CAUTION: Make sure that the area around the component is clean and free of foreign material.

NOTE: Install new gaskets.

Renew Part: Turbocharger oil return pipe to turbocharger gasket Quantity: 1 .

Torque Specification: 9 Nm
Torque Specification: 9 Nm
WARNING: Be prepared to collect escaping oil.

CAUTION: Make sure that new sealing washers are installed.

Renew Part: Turbocharger oil feed pipe banjo bolt Quantity: 1 .

Renew Part: Turbocharger oil feed pipe banjo bolt washers Quantity: 1 .

Torque Specification: 30 Nm
CAUTION: Apply Loctite 243 to the bolts.

NOTE: Make sure to clean the threads prior to installation.

Torque Specification: 32 Nm
WARNING: Be prepared to collect escaping fluids.

Torque Specification: 11 Nm
WARNING: Be prepared to collect escaping fluids.

CAUTION: Remove and discard the O-ring seal.

Renew Part: Turbocharger coolant pipe Quantity: 1 .

Torque Specification: 10 Nm
NOTE: Remove and discard the nut.

Renew Part: Exhaust manifold to turbocharger nuts Quantity: 1 .

Torque Specification: 26 Nm
NOTE: Remove and discard the nut.

Renew Part: Exhaust manifold to turbocharger nuts Quantity: 1 .

Renew Part: Turbocharger to exhaust manifold gasket Quantity: 1 .

Torque Specification: 26 Nm
NOTE: Remove and discard the gasket.

Renew Part: Turbocharger coolant pipes to turbocharger gasket Quantity: 1 .

Torque Specification: 9 Nm