Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.

CAUTION: Make sure that the mating faces are clean and free of corrosion and foreign material.

NOTE: Install a new gasket.

Renew Part: Fixed vane turbocharger actuator gasket kit Quantity: 1 .
CAUTION: Make sure that the mating faces are clean and free of corrosion and foreign material.

NOTE: Install a new gasket.
CAUTION: Install all the bolts finger tight before final tightening.
- Using a suitable 130mm T30 Torx socket, remove the retaining bolts.
  Torque Specification: 12 Nm
Torque Specification: 9 Nm
Torque Specification: 9 Nm
Refer to: ENGINE UNDERSHIELD
Refer to: EXHAUST SYSTEM - VEHICLES WITH: DIESEL PARTICULATE FILTER (DPF)
Refer to: EXHAUST SYSTEM - VEHICLES WITHOUT: DIESEL PARTICULATE FILTER (DPF)
If a new fixed vane turbocharger actuator is installed, carry out the reset procedure for the fixed vane turbocharger actuator using approved diagnostic tool.