Removal And Installation: Removal
WARNING: This page is about a different variant/trim than selected.
WARNING:
Wait for a minimum of 1 minute after the engine has stopped before carrying out any repair to the fuel injection system.
CAUTION:
Before disconnecting or removing components, ensure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.
NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
- Disconnect the startup battery ground cable.
Refer to: BATTERY AND CABLES
- Refer to: SECONDARY BULKHEAD CENTER PANEL - TDV6 3.0L DIESEL
- Refer to: COOLING SYSTEM PARTIAL DRAINING AND VACUUM FILLING
- Refer to: LEFT EXHAUST GAS RECIRCULATION VALVE OUTLET TUBE
- Refer to: LEFT EXHAUST GAS RECIRCULATION VALVE - TDV6 3.0L DIESEL - GEN 2
- Refer to: FUEL INJECTION COMPONENT CLEANING
-
CAUTION: Be prepared to collect escaping fuel.
-
CAUTION: Be prepared to collect escaping fuel.
-
CAUTION: Be prepared to collect escaping fuel.
-
CAUTION: Be prepared to collect escaping fuel.
-
CAUTION: Be prepared to collect escaping fuel.
-
CAUTION: Be prepared to collect escaping fuel.
-
CAUTION: Be prepared to collect escaping fuel.
-
CAUTION: Be prepared to collect escaping fuel.
-
CAUTION: Be prepared to collect escaping fuel.
-
CAUTION: Be prepared to collect escaping fuel.