General Procedures
WARNING: This page is about a different variant/trim than selected.
| 19.50.22 | FUEL INJECTION COMPONENT CLEANING USING A VACUUM GUN | 3000 CC, TDV6 | 0.1 |
WARNING:
Do not carry out any repairs to the fuel system with the engine running. The fuel pressure within the system can be as high as 1700 bar (24, 656 lb-sq-in). Failure to follow this instruction may result in personal injury.
CAUTION:
Before using the cleaning fluid, protect all electrical components and connectors with lint-free non-flocking material.
NOTE:
Pneumatic vacuum gun
- Using a new brush that will not lose its bristles, brush cleaning fluid onto the components being removed and onto the surrounding area.
- Using a pneumatic vacuum gun, remove all traces of cleaning fluid and foreign material.
- Dispose of any used cleaning fluid and the brush after completing the repair.