LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2016 >> Range Rover Supercharged >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine - TDV6 3.0L Diesel - Gen 2/TDV6 3.0L Diesel -- Range Rover/L405) >> Engine - TDV6 3.0L Diesel - Gen 2/TDV6 3.0L Diesel >> Exhaust Manifold Cross-Over Pipe >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different variant/trim than selected.
CAUTION: Take care when handling the cross-over pipe as damage to the insulating material may occur.
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
  1. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  2. Refer to: EXHAUST SYSTEM - VEHICLES WITHOUT: DIESEL PARTICULATE FILTER (DPF)

    Refer to: EXHAUST SYSTEM - VEHICLES WITH: DIESEL PARTICULATE FILTER (DPF)

  3. Refer to: TRANSMISSION SUPPORT CROSSMEMBER - TDV6 3.0L DIESEL
  4. NOTE: The transmission is lowered for access.
    G11602046
    • General Equipment: Transmission jack 
  5. G11602047
  6. G11602048
  7. G11602049
  8. G11607496
  9. CAUTION: Discard the nuts.
    G11602051
  10. CAUTION: Discard the nuts and bolt.
    G11602052
  11. G11602053
  12. CAUTION: Discard the studs.
    G11695734
  13. CAUTION: Discard the studs.
    G11695735
  14. NOTE: Discard the gasket.
    G11602056