Removal And Installation: Installation
WARNING: This page is about a different variant/trim than selected.
- NOTE: Install new gaskets.
Renew Part: Exhaust manifold cross-over pipe gaskets Quantity: 1 .
- NOTE: New exhaust manifold retaining studs must be fitted if the old studs are removed.
Renew Part: Exhaust manifold cross-over pipe studs Quantity: 1 .
Torque Specification: 13 Nm
- NOTE: New exhaust manifold retaining studs must be fitted if the old studs are removed.
Renew Part: Exhaust manifold cross-over pipe studs Quantity: 1 .
Torque Specification: 13 Nm
- CAUTION: New exhaust manifold nuts and bolt must be fitted.
Renew Part: Exhaust manifold cross-over pipe nuts and bolts Quantity: 1 .
Check for correct alignment.
Torque Specification: 23 Nm
Check for correct alignment.
Torque Specification: 23 Nm
Torque Specification: 23 Nm
Torque Specification: 23 Nm
Torque Specification: 11 Nm
General Equipment: Transmission jack
- Refer to: TRANSMISSION SUPPORT CROSSMEMBER - TDV6 3.0L DIESEL
- Refer to: EXHAUST SYSTEM - VEHICLES WITHOUT: DIESEL PARTICULATE FILTER (DPF)
Refer to: EXHAUST SYSTEM - VEHICLES WITH: DIESEL PARTICULATE FILTER (DPF)