LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Electronic Engine Controls - V8 S/C 5.0L Petrol -- Range Rover/L405) >> Electronic Engine Controls - V8 S/C 5.0L Petrol >> Post Catalyst Heated Oxygen Sensor >> Removal And Installation >> Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, 2016 Land Rover Range Rover, 2014 Land Rover Range Rover, and 2013 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
  1. CAUTION: Make sure the anti-seize compound does not contact the HO2S tip.
    NOTE: If the original sensor is to be installed, apply lubricant meeting specification ESE-M12A4-A to the thread of the sensor.
    • Using the special tool install the Heated Oxygen Sensor (HO2S). Special Tool(s): JLR-303-1666  Torque Specification: 48 Nm 
    • Connect the electrical connector.
    • Install the heatshield.
scientia non olet · About LEMON Manuals