LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Electronic Engine Controls - V8 S/C 5.0L Petrol -- Range Rover/L405) >> Electronic Engine Controls - V8 S/C 5.0L Petrol >> Brake Pedal Position Switch Adjustment >> General Procedures >> Check

General Procedures: Check

WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, 2016 Land Rover Range Rover, 2014 Land Rover Range Rover, and 2013 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the brake pedal rubber.
  2. NOTE: Make sure that the dial test indicator (DTI) gauge is in line with the brake pedal movement.
    G11608468

    Position the DTI gauge on a suitable mounting block, as illustrated.

  3. With the aid of another technician, gently press the brake pedal until the stop lamps illuminate.
  4. NOTE: The specification is that the stop lamps should illuminate at between 5.5 mm and 8.5mm brake pedal travel.

    Note the measurement of the brake pedal travel from rest position until the stop lamps illuminated.

scientia non olet · About LEMON Manuals