LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2015 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Electronic Engine Controls - V8 S/C 5.0L Petrol -- Range Rover/L405) >> Electronic Engine Controls - V8 S/C 5.0L Petrol >> Brake Pedal Position Switch Adjustment >> General Procedures >> Adjust

General Procedures: Adjust

WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, 2016 Land Rover Range Rover, 2014 Land Rover Range Rover, and 2013 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The Brake Pedal Position Switch is self adjusting when removed and installed.
  1. Remove and install Brake Pedal Position Switch.

    For additional information, refer to: STOPLAMP SWITCH

  2. Check the adjustment of the stop lamp switch by following the Check  procedure in this procedure and carry out the Adjust  procedure if required.
scientia non olet · About LEMON Manuals