LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2014 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Fuel Charging & Controls - Turbocharger - TDV6 3.0L Diesel -- Range Rover/L405) >> Fuel Charging And Controls - Turbocharger - TDV6 3.0L Diesel >> Fixed Vane Turbocharger Actuator >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Some variation in the illustrations may occur, but the essential information is always correct.
  1. WARNING: Make sure to support the vehicle with axle stands.

    Raise and support the vehicle.

  2. Refer to: EXHAUST SYSTEM - VEHICLES WITH: DIESEL PARTICULATE FILTER (DPF)

    Refer to: EXHAUST SYSTEM - VEHICLES WITHOUT: DIESEL PARTICULATE FILTER (DPF)

  3. Refer to: ENGINE UNDERSHIELD
  4. NOTE: Engine shown removed for clarity.
    G11607466
  5. G11607467
  6. G11607468
  7. CAUTION: Remove the Torx screws evenly and progressively.
    G11607469

    Using a suitable 130mm T30 Torx socket, remove the retaining bolts.

  8. NOTE: Make a note of the orientation of the gasket tang.
    G11607470
  9. NOTE: Remove and discard the gasket.
    G11607471
scientia non olet · About LEMON Manuals