DTC U0415-68: Invalid Data Received From Anti-Lock Brake System (ABS) Control Module - Event information: Action
WARNING: This page is about a different car, the 2018 Land Rover Range Rover, 2017 Land Rover Range Rover, and 2016 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The FlexRay wiring harness must not be repaired by making a localized wiring repair. A new wiring harness should be installed.
- Refer to the appropriate system wiring diagram and check the anti-lock brake system control module power and ground circuits for open circuit, high resistance. Repair the wiring harness as necessary
- Refer to the appropriate system wiring diagram and check the FlexRay bus circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness as necessary
- Using the Jaguar Land Rover approved diagnostic equipment, check the anti-lock brake system control module for related DTCs and refer to the relevant DTC index
- Check the installation of the brake pedal switch. Rectify as necessary
- Refer to the appropriate system wiring diagram and check the brake pedal switch circuit for short circuit to ground, short circuit to power, open circuit, high resistance. Repair the wiring harness as necessary
- Install a new brake pedal switch