Module Circuit Inspection
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
OCS ECU connector | 3 (ON/START Input) | Chassis ground | - | B+ |
|
OCS ECU connector | 4 (ground) | Chassis ground | - | Approx. below 1Ω |
Good
- Carefully re-do this troubleshooting guide steps.
- If problem still occurs, replace OCS mat and then go to "BODY SENSOR RESET " and "Verification Of Repair" procedure.
No Good
- Repair as necessary and then go to "BODY SENSOR RESET " and "Verification Of Repair" procedure.