Shift Cable Inspection

WARNING: This page is about a different variant/trim than selected.

Shift gear lever to "N".
Check the matching of the manual control lever and position sensor "N" position.
"N" position check procedure.
- Insert the jig (Ø5) into the "N" position setting hole. (Refer to Fig.1)
When you insert the jig, there shall be no such strain/jam between manual control lever and cable lever.
If the strain or jam occur, remove the shift cable nut and adjust the position of Position sensor.
Remove the jig from the "N" position setting hole.
Shift gear lever from "P" to "D" after procedure completion two times.

Courtesy of KIA MOTORS AMERICA, INC.

Good

Fault might be intermittent and caused either by poor contact in connector or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connector (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
Repair or replace as necessary and then go to "VERIFICATION OF REPAIR " procedure.

No Good