Module Inspection
WARNING: This page is about a different car, the 2024 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.
| Module Inspection | |||||
|---|---|---|---|---|---|
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
| Connector | Terminal | Connector | Terminal | ||
| 1. Disconnect the electrical connector(s) from the concerned component. 2. Ignition "ON". |
AMP connector | 1, 2, 3, 4, 8, 24 (power) | Chassis ground | - | B+ |
| 1. Ignition "OFF". 2. Disconnect the electrical connector(s) from concerned component. |
AMP connector | 16, 17, 18, 19 (ground) | Chassis ground | - | Approx. below 1Ω |
Good
• Go to ("CAN Inspection ") procedure.
No Good
• Repair as necessary and then go to ("Verification Of Repair ") procedure.
• Repair open or short in circuit and then go to ("Verification Of Repair ") procedure.