Circuit Inspection

WARNING: This page is about a different variant/trim than selected.

G13690100

Courtesy of KIA MOTORS AMERICA, INC.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "ON".	TCU	20 (P-CAN high)	Chassis ground	-	Fig.1
Ignition "ON".	TCU	19 (P-CAN low)	Chassis ground	-	Fig.1
Ignition "OFF". Refit all connectors of each control module (refer to circuit) of P-CAN communication.	TCU	20 (P-CAN high)	TCU	19 (P-CAN low)	Approx. 60Ω
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component.	ECM (component side)	83 (P-CAN high)	ECM (component side)	82 (P-CAN low)	Approx. 120Ω
	ICU (component side)	17 (P-CAN high)	ICU (component side)	18 (P-CAN low)	Approx. 120Ω

G13690101

Courtesy of KIA MOTORS AMERICA, INC.

Good

Go to "COMPONENT INSPECTION " procedure.

No Good

Repair open or short in circuit and then go to "VERIFICATION OF REPAIR " procedure.
Check CAN communication circuit for open circuit or short circuit after repair, go to "VERIFICATION OF REPAIR "