Circuit Inspection

WARNING: This page is about a different variant/trim than selected.

G13291832

Courtesy of KIA MOTORS AMERICA, INC.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component. Ignition "ON".	Transmission range switch connector	5 (power)	Chassis ground	-	Approx. 5V
	Transmission range switch connector	7(S1)	Chassis ground	-	Approx. 0V
	Transmission range switch connector	8(S2)	Chassis ground	-	Approx. 0V
Ignition "OFF". Disconnect the electrical connector(s) from the concerned component.	Transmission range switch connector	6 (ground)	Chassis ground	-	Approx. 0V
	Transmission range switch connector	7 (S1)	Chassis ground	-	∞ (infinity)Ω
	Transmission range switch connector	8 (S2)	Chassis ground	-	∞ (infinity)Ω
	Transmission range switch connector	6 (ground)	Chassis ground	-	Approx. below 1Ω
	Transmission range switch connector	7 (S1)	PCM connector	27 (S1)	Approx. below 1Ω
	Transmission range switch connector	8 (S2)	PCM connector	8 (S2)	Approx. below 1Ω
	Transmission range switch connector	6 (ground)	PCM connector	70 (ground)	Approx. below 1Ω

Good

Go to "Component Inspection " procedure.

No Good

Repair open or short in signal circuit between inhibitor switch and TCM and then go to "Verification of Repair " procedure.