Component Inspection

WARNING: This page is about a different variant/trim than selected.

Inspection Condition	(+) Probe		(-) Probe		Specification
Inspection Condition	Connector	Terminal	Connector	Terminal	Specification
Engine "ON". Gear lever position at "P"	Transmission range switch connector	6 (ground)	Transmission range switch connector	5 (power)	Fig.1
Engine "ON". Gear lever position at "P"	Transmission range switch connector	7(S1)	Transmission range switch connector	8 (S2)	Fig.1
Engine "ON". Gear lever position at "R"	Transmission range switch connector	6 (ground)	Transmission range switch connector	5 (power)	Fig.2
Engine "ON". Gear lever position at "R"	Transmission range switch connector	6 (ground)	Transmission range switch connector	8 (S2)	Fig.2
Engine "ON". Gear lever position at "N"	Transmission range switch connector	7 (S1)	Transmission range switch connector	5 (power)	Fig.3
Engine "ON". Gear lever position at "N"	Transmission range switch connector	6 (ground)	Transmission range switch connector	8 (S2)	Fig.3
Engine "ON". Gear lever position at "D"	Transmission range switch connector	7 (S1)	Transmission range switch connector	5 (power)	Fig.4
Engine "ON". Gear lever position at "D"	Transmission range switch connector	6 (ground)	Transmission range switch connector	8 (S2)	Fig.4

G13291833

Courtesy of KIA MOTORS AMERICA, INC.

G13291834

Courtesy of KIA MOTORS AMERICA, INC.

G13291835

Courtesy of KIA MOTORS AMERICA, INC.

G13291836

Courtesy of KIA MOTORS AMERICA, INC.

Good

Carefully re-do this troubleshooting guide steps.
Check the alignment of shift cable. If problem occurs, align the cable and then go to "Verification of Repair " procedure
If problem still occurs, replace PCM and then go to "Verification of Repair " procedure.

No Good

Carefully re-do this troubleshooting guide steps.
If problem still occurs, replace inhibitor switch and then go to "Verification of Repair " procedure.