LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Optima SX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 31 (Dual Clutch Transmission Diagnosis - 1.6L (2 Of 2) (Except HEV)) >> DTC U0121-87: Lost Communication With Anti-Lock Brake System (ABS) Control Module >> Wiring Inspection >> CAN Communication Line Inspection >> CAN resistor inspection

CAN resistor inspection

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF.
  2. Disconnect Battery (-) terminal.
  3. Disconnect ECM and Cluster connectors.
  4. Measure resistance between Pin No. 63 (C-CAN Low) and Pin No. 85 (C-CAN High) terminal of ECM.
  5. Measure resistance between Pin No. 33 (C-CAN Low) and Pin No. 32 (C-CAN High) terminal of Cluster.

    Specification:  About 120Ω

  6. Is measured value within specification?

    YES 

    NO 

    • Carefully re-do this troubleshooting guide steps.
    • If problem still occurs, replace ECM/PCM or Cluster whichever has defected resistor and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals