LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Optima SX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 31 (Dual Clutch Transmission Diagnosis - 1.6L (2 Of 2) (Except HEV)) >> DTC U0121-87: Lost Communication With Anti-Lock Brake System (ABS) Control Module >> Wiring Inspection >> CAN Communication Line Inspection >> Short in CAN Communication Line Inspection

Short in CAN Communication Line Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Ignition "ON".
  2. Measure voltage between Pin No. 26 (CAN High) terminal of ESP and chassis ground.
  3. Measure voltage between Pin No. 14 (CAN Low) terminal of ESP and chassis ground.

    Specification:  CAN High Voltage - Approx. 3.28V/CAN Low Voltage - Approx. 1.87V

  4. Ignition "Off"
  5. Disconnect TCM and ECM/PCM connectors.
  6. Measure resistance between Pin No. 44 (CAN High) terminal of TCM and Pin No. 26 (CAN High) terminal of ABS.
  7. Measure resistance between Pin No. 45 (CAN Low) terminal of TCM and Pin No. 14 (CAN Low) terminal of ABS.

    Specification:  Approx. 0Ω

  8. Is measured value within specification?

    YES 

    NO 

scientia non olet · About LEMON Manuals