Ground Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
- Ignition "OFF"
- Refer to "GEAR ACTUATOR ASSEMBLY " and disconnect Gear Shift Actuator connector.
- Ignition "ON"
- Measure resistance between Pin No. 5 (ground) terminal of Gear Shift Actuator harness connector and chassis ground.
Specification: Approx. 0Ω
- Is measured value within specification?
YES
- Go to "HALL SIGNAL CIRCUIT INSPECTION " procedure.
NO
- Repair open or short in ground circuit between Gear Shift Actuator and TCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.