Hall Signal Circuit Inspection

WARNING: This page is about a different variant/trim than selected.

Ignition "OFF"
Refer to "GEAR ACTUATOR ASSEMBLY " and disconnect Gear Shift Actuator connector.
Ignition "ON"
Measure voltage between Pin No. 8, 11, 14 (Hall Signal) terminal of Gear Shift Actuator harness connector and chassis ground.
Specification: Approx. 4.6V
Is measured value within specification?
YES
- If problem still occurs, replace "Gear Shift Actuator" and then go to "VERIFICATION OF REPAIR " procedure.
NO
- Repair open or short in signal circuit between Gear Shift Actuator and TCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.