Circuit Inspection
WARNING: This page is about a different car, the 2021 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
| Item | Normal Value | Prerequisite Condition | Probe (+) | Probe (-) |
|---|---|---|---|---|
| CAN Communication Line: Resistance | Approx. 60Ω |
|
TCM CAN High terminal | TCM CAN Low terminal |
| Approx. 120Ω |
|
ECM CAN High terminal (Component side) | ECM CAN Low terminal (Component side) | |
| Approx. 120Ω |
|
BCM CAN High terminal (Component side) | BCM CAN Low terminal (Component side) |
- Is the value within specification?
YES
- This can be an intermittent fault caused by poor contact in the sensor's and/or control module's connector. Or, control module's memory was not cleared after repair. Thoroughly check connectors for looseness, poor connection, ending, corrosion, contamination, deterioration, or damage.
- Repair or replace the relevant component(s) as necessary, and go to "VERIFICATION OF VEHICLE REPAIR ".
NO
- Go to next procedure.