LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2018 >> Sorento L >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Electronic Parking Brake Diagnosis >> DTC C1616-08: C-Can Bus Off >> Wiring Inspection >> CAN Communication Circuit Inspection >> Resistance Measurement With Matching Resistor

Resistance Measurement With Matching Resistor

  1. Ignition "OFF" and disconnect the battery and wait about four minutes.
  2. Make sure all modules are properly connected.
  3. Measure resistance between Pin No. 15 (C-CAN High) and Pin No. 16 (C-CAN Low) terminal of IGPM harness connector.

    Specification:  Approx. 60 Ω

  4. Is the measured value within specification?

    YES 

    NO 

    • If the value is out of specification then, go to "CAN Resistor Inspection " procedure below.

      * If the measured value is approx. 00, then check for short CAN communication line.

      * If the measured value is approx. "O, then check for open CAN communication line.

scientia non olet · About LEMON Manuals