LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2016 >> Optima SX Limited >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 91 (Engine Control System Diagnosis - 1.6L (3 Of 3) - Optima (Except HEV)) >> DTC U0001: High Speed CAN Communication Bus Off >> Wiring Inspection >> Signal Circuit Inspection

Signal Circuit Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Ignition "OFF"
  2. Disconnect CAN communication modules. (ECM)
  3. Measure resistance between Pin No. 3 (CAN-High) terminal of DLC harness connector and chassis ground.
  4. Measure resistance between Pin No. 11 (CAN-Low) terminal of DLC harness connector and chassis ground.

    Specification:  ∞ Ω

  5. Measure voltage between Pin No. 3 (CAN-High) terminal of DLC harness connector and chassis ground.
  6. Measure voltage between Pin No. 11 (CAN-Low) terminal of DLC harness connector and chassis ground.

    Specification:  0 V

  7. Is the measured Value within specification?

    YES 

    NO 

scientia non olet · About LEMON Manuals