Fuel Control Module Inspection
WARNING: This page is about a different variant/trim than selected.
- Check the fuel pump fuse (20A).
- Ignition "OFF" and disconnect Fuel Control Module connector.
- Measure voltage between Pin No. 10 (Power) terminal of Fuel Control Module harness connector and chassis ground. (Measure the control circuit while turn the ignition switch "OFF" to "ON".)
Specification: Approx. 0V →12V
- Is the measured voltage within specification?
YES
- Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Go to "COMPONENT INSPECTION " procedure.