Ground Circuit Inspection

■ Open or Short Check 

1. IG "OFF".
2. Disconnect yaw rate & lateral G & longitudinal G sensor connector.
3. Measure resistance between ground terminal of the Yaw rate sensor harness connector and chassis ground.

   Specification:  Approx. below 1Ω

4. Is the measured value within specifications?

   YES 

   • Go to "SIGNAL CIRCUIT INSPECTION " procedure.

   NO 

   • Repair open or short in ground circuit between the Yaw rate sensor harness connector and HECU harness connector and then, go to "VERIFICATION OF VEHICLE REPAIR ".