Signal circuit inspection

■ Open or Short Check 

1. IG "OFF".
2. Disconnect HECU and EPB ECU connector.
3. Measure resistance between CAN HIGH (LOW) terminal of the HECU harness connector and CAN HIGH (LOW) terminal of the EPB ECU harness connector.

   Specification:  Approx. below 1Ω

4. Is the measured value within specifications?

   YES 

   • Go to "COMPONENT INSPECTION " procedure.

   NO 

   • Repair open in CAN BUS line between HECU harness connector and EPB ECU harness connector and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.