DTC B1369: Passenger Seat Belt PRETENSIONER Short To Ground

WARNING: This page is about a different car, the 2002 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.

Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Remove driver-side air bag module. Disconnect passenger-side air bag module and seat belt pretensioner connectors. Disconnect SRSCM connector. Go to next step.
Measure resistance between passenger seat belt pretensioner high-side circuit terminal No. 4 and ground at SRSCM connector. See Figure. If resistance is infinite, go to next step. If resistance is not infinite, replace wire harness between SRSCM and passenger seat belt pretensioner. See WIRING DIAGRAMS .
NOTE: DTC's other than DTC B1369 may be retrieved by scan tool. They are not relevant to this test.
Connect passenger seat belt pretensioner connector. Connect SRSCM connector. Turn ignition on. Wait at least 30 seconds. Using scan tool, clear DTC's. Turn ignition off. Wait at least 30 seconds. Turn ignition on. Wait at least 30 seconds. Using scan tool, retrieve DTC's. If DTC B1369 is retrieved, replace passenger seat belt pretensioner. See SEAT BELT PRETENSIONER under REMOVAL & INSTALLATION. If DTC B1369 is not retrieved, system is okay.