Air Bag Safety Precautions

WARNING: This page is about a different car, the 2002 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.

Observe these precautions when servicing the air bag system:

Disable air bag system before servicing any air bag system or steering column component. See DISABLING & ACTIVATING AIR BAG SYSTEM .
When trouble shooting air bag system, always check diagnostic codes before disconnecting battery.
After turning ignition switch off and disconnecting negative battery cable, wait at least 30 seconds before working on air bag system. Air bag system is equipped with a back-up power source that may allow air bags or seat belt pretensioners to deploy up to 30 seconds after negative battery cable is disconnected.
When welding on vehicle, disconnect negative battery cable and all air bag module connectors before beginning work.
During servicing of air bag system, store air bag module where ambient temperature is less than 200°F (93°C) and humidity and electrical noise are low.
When placing a live air bag on a bench or other surface, ensure trim cover is facing up, away from work surface. This will reduce motion of module if it is accidentally deployed.
When carrying air bag module, point cover away from body to lessen chance of injury during accidental deployment.
Because of critical system operating requirements, DO NOT attempt to service any SRS component. Corrections are made by replacement with new parts only. Never use parts from another vehicle.
If any SRS component has been dropped or there are cracks, dents or other defects visible, replace with new part.
DO NOT attempt to measure resistance across air bag module or seat belt pretensioner squib connector. Accidental component deployment is possible, which could cause personal injury.
After deployment, air bag surface may contain deposits of sodium hydroxide from gas generant combustion which can irritate skin. Always wear safety glasses, rubber gloves and long-sleeved shirt during clean-up. Wash hands using mild soap and water.
After work on air bag system is completed, ensure system is functioning properly. See SYSTEM OPERATION CHECK .