Section 45 (Hybrid Control Processor Module (HCP) - DTCS P160A-00 To P1A1E-00)

• DTC Troubleshooting
  • P160A-00-Ecu Over Temperature
    • High Voltage Warning
    • Diagnostic Test - Informational Only DTC
  • P161A-00-Ecu In - Plant Mode Active
    • High Voltage Warning
    • Diagnostic Test - Informational Only DTC
  • P167B-00-Controlled System Shutdown
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P16F0-00-SPI Comm Hardware Fault
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P16F1-00-Internal SPI Communication
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P16F3-00-Internal Control Module Redundant Memory Performance
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P16F5-00-HCP Internal - PLD Failure
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P16F9-00-HCP Internal - Shutdown Performance
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P1A11-00-Secret Key Not Stored In Ecu
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P1A1E-00-Hybrid Thermal System Control Circuit
    • Theory Of Operation
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test