Left Catalytic CONVERTOR Heat Shield: Notes
WARNING: This page is about a different car, the 2024 Jeep Grand Cherokee L. However, it is still accessible from the selected car via links, so may be relevant.
REMOVAL
- Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
- Remove the side belly pan. Refer to SIDE BELLY PAN .
- Remove the left catalytic convertor assembly. Refer to CONVERTER, CATALYTIC, REMOVAL AND INSTALLATION .
- Remove the catalytic converter heat shield nuts and the catalytic convertor heat shield.
1 - Heat Shield 2 - Heat Shield Nuts (Plastic) 3 - Heat Shield Nuts (Steel)
INSTALLATION
Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.
- Start the engine and inspect for exhaust leaks. Repair the exhaust leaks as necessary.