LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2023 >> Cherokee Trailhawk >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.0L Engine (Service Information) (2 Of 2) >> Engine Mounting >> Insulator, Engine Mount, Right >> Removal

Insulator, Engine Mount, Right: Removal

  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Remove the belly pan. Refer to BELLY PAN, REMOVAL .
  3. If equipped, remove the skid plate. Refer to PLATE, SKID, SIDE, REMOVAL .
  4. Remove the left front wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL .
    GC0183773Courtesy of CHRYSLER GROUP, LLC
  5. Remove the fastener (1) and remove the negative battery cable (2) from the transmission (3).
    CAUTION:

    Failure to remove the negative battery cable may overstress to the cable due to bending during service.

  6. Remove the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL .
    GC0186931Courtesy of CHRYSLER GROUP, LLC
  7. Remove the strut tower bolt (1), engine mount bolt (3) and the engine mount support bracket (2).
    GC0187112Courtesy of CHRYSLER GROUP, LLC
  8. Using a paint pen or marker, mark the location of the right isolator on the engine mount bracket (5).
  9. Support the powertrain with a suitable jack.
  10. Remove the three isolator to bracket bolts (6, 7).
  11. Remove the isolator to strut tower bolt (2).
  12. Remove the two isolator to frame rail bolts (3) and remove the right engine mount isolator (1).
scientia non olet · About LEMON Manuals