LEMON Manuals: Even more car manuals for everyone
Home >> Jeep >> 2023 >> Cherokee Trailhawk >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 2.0L Engine (Service Information) (2 Of 2) >> Engine Block >> Damper, Vibration >> Removal

Damper, Vibration: Removal

  1. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  2. Remove the accessory drive belt. Refer to BELT, SERPENTINE, REMOVAL .
  3. Remove the right front tire and wheel assembly and the front wheelhouse inner splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL .
    GC0181046Courtesy of CHRYSLER GROUP, LLC
  4. Install the (special tool #2054400090, Holder, Front Damper 4 Finger SHALLOW) (2) on the crankshaft damper (1) and loosen the damper bolt.
    GC0182238Courtesy of CHRYSLER GROUP, LLC
  5. Remove the bolt (3), washer (2) and the damper (1) from the crankshaft.
    GC0183581Courtesy of CHRYSLER GROUP, LLC
  6. There is a friction shim (1) attached to the front and rear of the crankshaft sprocket. Verify that the friction shim (1) is still in place on the front of the crankshaft sprocket.
scientia non olet · About LEMON Manuals