Antenna, Long-Term Evolution 2 (LTE2): Installation

Courtesy of CHRYSLER GROUP, LLC

1. Connect the wire harness connector (2) to the Long Term Evolution 2 (LTE2) antenna.
2. Position the LTE2 antenna to the instrument panel carrier, then install the fasteners (1) and tighten them securely.
3. Position and secure the instrument panel wire harness in its original location.
4. Install the instrument panel cover. Refer to PAD, INSTRUMENT PANEL, INSTALLATION .
5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.