Valves, Intake And Exhaust: Removal
WARNING: This page is about a different variant/trim than selected.
NOTE:
The intake and exhaust springs are NOT interchangeable. Mark the springs accordingly for installation. Correctly identify the part numbers for new springs being installed.
- Remove the cylinder head. Refer to CYLINDER HEAD, REMOVAL .
- Install the (special tool #10224, Adapter, Valve Spring) (2) on the (special tool #C-3422-D, Compressor, Valve Spring) (1).
- Install the valve spring compressor (1) onto the cylinder head.
- Using the (special tool #10224, Adapter, Valve Spring) (2) mounted in the (special tool #C-3422-D, Compressor, Valve Spring) (1), compress valve spring (3) and remove the valve retaining locks (4).NOTE:
The intake and exhaust springs are NOT interchangeable. Mark the springs accordingly for installation. Correctly identify the part numbers for new springs being installed.
NOTE:If the springs are to be reused, identify their positions so that they can be reassembled into their original locations.
- Release the valve spring compression and remove the valve spring retainer (1) and valve spring (2).
- If required, remove the valve guide seal (2). Refer to SEAL(S), VALVE GUIDE, REMOVAL .CAUTION:
Before removing the valves, remove any burrs from the valve stem retainer lock grooves (2) and stem tip (1) to prevent damage to the valve guides.
- Remove the valve(s). Identify each valve to ensure installation in the original location.