Off Vehicle
WARNING: This page is about a different variant/trim than selected.
- If removed, install the valves. Refer to VALVES, INTAKE AND EXHAUST, INSTALLATION .NOTE:
Reassemble the valves into their original locations. If the valves or valve seats have been refinished, verify that the valve stem tip height (5) is within specification. Refer to ENGINE SPECIFICATIONS .
- If removed, install the valve guide seal (2) over the valve guide. Refer to SEAL(S), VALVE GUIDE, INSTALLATION .NOTE:
Make sure that the garter spring (1) is intact around the top of the valve guide seal (2).
NOTE:The intake and exhaust springs are NOT interchangeable. Mark the springs accordingly for installation. Correctly identify the part numbers for new springs being installed.
NOTE:If the valve springs are being reused, reassemble them into their original locations.
- Install the (special tool #10224, Adapter, Valve Spring) (2) on the (special tool #C-3422-D, Compressor, Valve Spring) (1).
- Using the (special tool #10224, Adapter, Valve Spring) (2) mounted in the (special tool #C-3422-D, Compressor, Valve Spring) (1), compress valve spring (3) only enough
to install the valve retaining locks (4).
- If the valves or valve seats have been refinished, verify that the installed height of the valve springs (4) are within specification. Make sure the measurement is taken from the top of spring seat (6) to the bottom surface of spring retainer (2). Refer to ENGINE SPECIFICATIONS .
- Install the cylinder head. Refer to CYLINDER HEAD, INSTALLATION .