Seal(S), Valve Guide: Installation
WARNING: This page is about a different variant/trim than selected.
- If removed, install the valve(s). Refer to VALVES, INTAKE AND EXHAUST, INSTALLATION .NOTE:
The valve spring seat is integral to the valve guide seal. Intake and exhaust valve guide seals are unique.
- Apply engine oil to the lip of the valve guide seal (2). Install the valve guide seal over the valve stem. Using an appropriate driver, push the seal firmly and squarely over the valve guide. Do Not Force
the seal against the top of guide.NOTE:
Make sure that the garter spring (1) is intact around the top of the valve guide seal.
- Install the valve spring(s). Refer to SPRING(S), VALVE, INSTALLATION .
NOTE:
If the valve springs are being reused, reassemble them into their original locations. Intake and exhaust springs are unique.